Tus neeg siv phau ntawv
Table Of Contents
- I. General
- III. Technical Specifications
- IV. Structure and Working Principle
- 2. Working principle
- The detector uses a high-precision thermistor sens
- V. Installation
- 1. Points for on-site installation
- The wireless performance indicators of this produc
- VI. Test
- Warning: Please make sure that the polarity of the
- 1. The detector must be tested after installation
- 2. Simulated fire alarm: After successfully connec
- 3. During the test, the unqualified detector shall
- VII. Use and Operation
- 1. Network segment setting: Before the detector co
- 2. The device enters and exits the network: After
- A) Network access operation: When the control pane
- B) Network exit operation: When the control panel
- 3. Equipment alarm: When the temperature in the en
- 4. Device reset: When the device reports a fire al
- 5. Restore factory settings: After the detector is
- Note: The button function only has one click, thre
Yingkou Tiancheng Fire Protection Equipment Co., LTD
The schematic diagram of the base of the detector is shown in Figure 3. Fix the base with two self-tapping screws
or stick it firmly with 3M glue. After the base is firmly installed, align the bottom of the detector and rotate the
base clockwise to install the detector on the base.
Fig.3 Schematic diagram of the base of the detector