Tus neeg siv phau ntawv
Table Of Contents
- I. General
- III. Technical Specifications
- IV. Structure and Working Principle
- 2. Working principle
- The detector uses a high-precision thermistor sens
- V. Installation
- 1. Points for on-site installation
- The wireless performance indicators of this produc
- VI. Test
- Warning: Please make sure that the polarity of the
- 1. The detector must be tested after installation
- 2. Simulated fire alarm: After successfully connec
- 3. During the test, the unqualified detector shall
- VII. Use and Operation
- 1. Network segment setting: Before the detector co
- 2. The device enters and exits the network: After
- A) Network access operation: When the control pane
- B) Network exit operation: When the control panel
- 3. Equipment alarm: When the temperature in the en
- 4. Device reset: When the device reports a fire al
- 5. Restore factory settings: After the detector is
- Note: The button function only has one click, thre
Yingkou Tiancheng Fire Protection Equipment Co., LTD
IV. Structure and Working Principle
1. The outline diagram of the detector is shown in Figure 1.
Fig.1 Outline diagram of the detector
2. Working principle
The detector uses a high-precision thermistor sensor, and the output signal of the sensor is input to the
single-chip microcomputer after voltage conversion, and the single-chip uses an intelligent algorithm for signal
processing. When the temperature in the environment reaches the alarm value, the red light of the detector will
be on, and an alarm signal will be sent to the control panel wirelessly. When used as a fire alarm device, the
detector is in the state of waiting for the control panel to reset during this process. If the fire alarm is not
cleared, the detector will resend the fire alarm signal to the control panel every ten minutes.
V. Installation
Warning: Before installing the detector, please make sure that the battery polarity is correct and that the base
has been installed firmly.
1. Installation method
The schematic diagram of the detector installation is shown in Figure 2.
Figure 2 Schematic diagram of the detector installation
1
0
0
54