Operation Manual

First Setup and Use
1.TurndownyourPA’smastervolume.
2.ConnectyourmicandPAasshowninthediagramfirst,thenplugintheACadaptor.Forlive
performance,aUSBconnectiontoacomputerisnotrequired.
3. Set the Reverb style to Hall and the mix control to the center notch.
4.SingintoyourmicwhileadjustingtheMICGAINcontrolsothattheinputlevelLEDflashesgreen.
BriefflashesofredontheLEDonyourloudestsingingareok.
5.Ensurethattheeffectison(centerLEDislit).
6.SingwhileturningupyourPAvolumetoacomfortablelevel.
You can now sing while you sample the different reverb styles and raise and lower the mix. You’re
ready to perform!
Phantom Power
ThereisnoswitchtoenablephantompowerontheVoiceTonesingles.Phantompowerisavailable
when the product is powered. Microphones that don’t require phantom power will operate properly.
AlwaysapplypowerasthelastconnectionstepandensureyourPAismuted.Thiswillreducethe
chance of audio pops that could harm your equipment.