Manual

PARAMETERS 15
ENGLISH
AT TAC K
The Attack control allows you to change how fast the correction adjusts the Input pitch to
the correct note.Very fast settings will produce unnatural sounding glitches—which are useful
for some creative applications—while slower settings will take longer to move to the correct
pitch.This can be well applied with ballads and more animated melodies.
ADAPTIVE LO CUT FILTER
The Adaptive Lo Cut Filter serves many cleanup functions that work in making a better vocal
recording.As you may expect, the filter can remove unwanted rumble in the low frequencies
and remove hum that found its way into your recording thanks to poorly shielded cables. It
can also be used to reduce breathing artifacts derived from a singer that is too close to the
microphone.
The low cut filter can either be off, on or adaptive. In adaptive mode, the cut-off frequency
adapts to the input pitch of a vocal.When adaptive mode is off, the cut-off frequency is
manually set.
The low-cut frequency can be set up to 266Hz when adaptive is off. However, in adaptive
mode, the frequency can be set to "infinite".This settings forces the low-cut to track just
below the input pitch of the vocal.
PARAMETERS 14
ENGLISH
MANUAL PITCH BENDER
The Manual Pitch Bender is used to manually control the absolute pitch.When using the
bender with automatic forms of correction, the Manual Pitch Bender is in addition to the
automatic correction .The pitch bend range is +/-600 cents.
AMOUNT
The amount control scales the amount of automatic correction applied to the input voice.
The range is from 0% to 100%. However, 0% does not mean that the correction is turned off.
The amount of correction that is applied depends on how far out of tune the input is.This
allows for a very musical way of correcting pitch, by correcting the large pitch errors while
preserving the natural micro variations around the correct pitch.
For example:
a) with the amount set to 100%, a 10 cent flat input pitch will be corrected by 10 cents and a
50 cent flat input pitch will be corrected by 50 cents.
b) with the amount set to 80%, a 10 cent flat input pitch will be corrected by approximetaly
8 cents and a 50 cent flat input pitch will be corrected by approxiametaly 40 cents.
c) with the amount set to 0%, a 10 cent flat input pitch will not be corrected and a
50 cent flat input pitch will be corrected by approximetaly 10 cents.