Quick Start Guide
14 HARMONY V100/ V60
クイックスタートガ イド
15
Harmony V100 Harmony V60
Footswitchable controls
Microphone Section
Talk on/o
Harmony on/o at the current setting
Reverb on/o
Echo on/o
Guitar section
Mute on/o
Chorus on/o
Reverb on/o
Echo on/o
Harmony on/o at a selected setting
Looper section
Tap Tempo
Play/record
Stop
LEDs Green when footswitch engaged, red when recording
Looper controls
Knobs Level (0 to 10)
Switches
Voice/all/guitar
Tap tempo
Play/record
Stop
Backlit switches Tap tempo (ash red at tempo), play/record (green play, red record), stop (red)
Rear panel section
Connections
AC input IEC
USB B type
Foot switch, 5-pin DIN (for FST4 only)
Guitar/right out, XLR male
Mic/left out, XLR male
Aux in, 3.5 mm
Switches
AC power on/o toggle
Top tweeter on/o
Guitar/right out, DI/FX/MIX selector
Mic/left out, DI/FX/MIX selector
Ground lift, XLR audio
Knobs Aux input level (0-10)
USB
Type Class compliant USB 2.0, type B
Supported Operating Systems Windows 7 or higher
Mac OS X 10.6.8 or higher
Windows driver Required driver is supplied
Audio input and output 2 channels, 24 bit, 48kHz
Amplier
Output power 110 W 80 W
Type Class- D
Protection Short circuit, thermal
Harmony V100 Harmony V60
Loudspeakers
Type 10" dual-concentric, Tannoy 8" dual-concentric, Tannoy
Impedance 4 Ω
Power handling 400 W 240 W
Top tweeter (switchable on/o) 1"
Impedance 4 Ω
Overall frequency response 80 Hz - 20 kHz (+/- 3 dB) 46 Hz - 24 kHz
(- 10 dB)
90 Hz - 20 kHz (+/- 3 dB) 60 Hz - 24 kHz
(- 10 dB)
Maximum SPL 118 dbSPL 115 dbSPL
Footswitch (supplied) (any switch can operate any footswitchable control)
Type FST4
Switches
Harmony on/o (with LED)
Vocal FX on/o (with LED)
Guitar FX on/o (with LED)
Looper on/o (with LED)
Power Supply
Mains Voltage 100-240 V~ 50/60 Hz
Power consumption 40 W 35 W
Mains connection Standard IEC receptacle
Power Switch Rocker, rear panel
Dimensions/Weight
Dimensions (H x W x D) 377 x 408 x 311 mm (14.8 x 16.1 x 12.2") 333 x 383 x 287 mm (13.1 x 15.1 x 11.3")
Weight 13.3 kg (29.3 lbs) 11.2 kg (24.6 lbs)