User Manual

4 CRITICAL MASS User Manual
Connection
•
• Connect a microphone to the MIC jack
•
• Connect the OUT jack to a mixer, interface or active speaker
•
• Connect the power cable (not included)
•
• Connect a micro USB cable to a computer (optional)
Changing the Batteries
The Critical Mass can operate on 4 AA batteries. Remove the single screw on
the bottom of the pedal to open the battery door. Make sure to observe correct
polarity when inserting the batteries.
Auto Gain
Critical Mass will automaticall
y adjust the gain setting for your microphone,
eliminating the need for manual adjustments and ensuring that a good signal is
passed to the mixer without any unwanted distortion.
24 V Phantom Power
Phantom power is always active on the Critical Mass. This will power condenser
microphones, but will not a ect dynamic mics.
Mic Control
Mic Control allows you to control the e ect's on/o status via an MP-75
microphone. Press and hold the footswitch while powering up the unit to
toggle Mic Control.
Note that when using a condenser microphone, Mic Control should be disabled
to prevent unwanted on/o switching.
Micro USB cable
MP-75 microphone
Mixing board
Power cable
2. Operation