Manual

5 WIRETAP RIFF RECORDER User Manual
3. Operation – Inputs,
Outputs and Controls
3.1 Power / Switching the eect on and o
(1) POWER input To power up your pedal, connect a power supply to its power
input socket. The power input socket of your TC ELECTRONIC eect pedal is a
standard 5.5/2.1 mm DC plug (centre = negative).
Your TC ELECTRONIC eect pedal requires a 9 V power supply providing
100 mA or more (not supplied). TC ELECTRONIC recommends using the
PowerPlug 9.
To minimize hum, use a power supply with isolated outputs.
(2) USB port Use the standard Mini-B USB port on your TC ELECTRONIC eect
pedal to connect your pedal to a computer. This will allow you to transfer
ris from the pedal to computer directly without using the app.
If there should be rmware updates for this pedal, they can also be installed
using the USB port – see “6.1 Updating the rmware”.
3.2 Switching
(3) FOOTSWITCH
• To start recording a ri, tap the footswitch.
• To stop the recording and save the ri in the pedal, tap the footswitch again.
Tip: If you make a mistake while recording a ri, you can instantly delete the ri
by pressing and holding the footswitch for 3 seconds.
(4) INDICATOR LED The LED lights up when the eect is switched on. The LED
will also ash Red/Green alternately when WireTap is “discoverable” to
Bluetooth* devices – see “3.5 Connecting to Bluetooth”.
3.3 Audio in and out
(5) AUDIO INPUT (mono) The audio input on the right side of this pedal is a
standard ¼" jack (mono/TS). Connect your guitar to the audio input on the
right side of your pedal using a regular ¼" mono cable.
(6) AUDIO OUTPUT (mono) The audio output on the left side of this pedal is a
standard ¼" jack (mono/TS). Connect the audio output of your pedal to the
next device in the signal chain using a regular ¼" mono cable.
3.4 Eects controls
(7) PLAY / STOP button
• To hear your last recorded ri press the play button.
• To stop playback, press play again.
• Holding down the play button for three seconds while a ri is playing will
delete the ri.
(8) FORWARD button
• To skip to the next ri press the forward button.
• Wiretap will “blink” when you reach the last track in your list.
(9) BACKWARD button
• To skip to the previous ri press the backwards button.
• Wiretap will “blink” when your reached the rst track in your list.
3.5 Connecting to Bluetooth
FORWARD + BACKWARD button
• Press the forward and backward buttons simultaneously to make WireTap
“discoverable” to other Bluetooth devices.
• The INDICATOR LED will ash Red/Green alternately when
WireTap is discoverable.
See “4.2 Pairing your WireTap pedal and the WireTap App” for more
detailed information.
(1)
(2)
(7)
(3)
(4)
(6)
(9)
(8)
(5)
*The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of the marks are under license.