Manual

9 VSS3 NATIVE User Manual
Early Gain
Range: OFF, -97 dB to 0 dB
< -40 dB in 3 dB steps
> -40 dB in 0.5 dB steps
The output level of the early reections. When set to “O,” the reverb eect will
consist entirely of the reverb tail.
Click on the "M" icon inside the control to mute the early reections for a quick
comparison of its eect. Hold Shift while clicking the “M” icon to mute both
Reverb and Early signals. This is useful for comparing the total eect of the reverb
and early signals without changing the dry signal.
Dry Gain
Range: OFF, -97 dB to 0 dB
< -40 dB in 3 dB steps
> -40 dB in 0.5 dB steps
Attenuates the dry signal level on the output of the plug-in, thus leaving the
reverb and early levels unaected. “O” equals a “kill-dry” setting.
Click on the Lock icon inside the control, and the dry gain value will not change
when a new preset is chosen.
Input Gain
Range: OFF, -97 dB to 0 dB
< -40 dB in 3 dB steps
> -40 dB in 0.5 dB steps
Sets the input level for the algorithm.
Click on the Lock icon inside the control, and the input gain value will not change
when a new preset is chosen.
Output Gain
Range: OFF, -97 dB to 0 dB
< -40 dB in 3 dB steps
> -40 dB in 0.5 dB steps
Sets the output level for the reverb.
Click on the Lock icon inside the control, and the output gain value will not
change when a new preset is chosen.
5.2.1 Focus Fields
Each of the six Focus Fields along the bottom can be assigned to any of the
available controls. These useful assignments remain visible when you switch to
dierent pages. For example, you can adjust the Master Decay while you are on
the Early page.
Click on ASSIGN in the lower left, and you will notice that the control knobs will
become blank. (This is a good reminder that you are in ASSIGN mode.) Click and
drag any of the controls and drop it down onto the desired Focus Field 1 to 6.
You can also click the desired focus eld and then click the control to assign to it.
When nished assigning, select the ASSIGN button again.
Click on the Pin Icon inside the ASSIGN button, and the Assigned Focus Fields will
remain when presets are changed, although the numeric values within the Focus
Fields will change to the new preset values.
In the example below, Focus Field 3 has become Hi Decay by dragging the control
down and releasing it over the Focus Field 3 button. It will stay like this, even
when you move to another page. Note that Focus Field 3 is highlighted in colour
while it is being assigned, as is the Hi Decay control.
When a control is assigned to a Focus Field, its number will appear in the control.
In this example, there is a "3" in Hi Decay, as it is assigned to Focus Field 3.