Manual

12 VSS3 NATIVE User Manual
Reverb Page continued
Decay/Crossover (blue controls)
Lo Decay
Range: 0.01 to 2.50 in 0.01 steps
Decay multiplier, relative to the Master Decay, for the frequencies below the Lo
Xover.
Example: When a decay multiplier is set to 1.25 and the Master Decay is 2.0
seconds, the resulting decay time will be 1.25 x 2 = 2.5 seconds.
Lo Mid Decay
Range: 0.01 to 2.50 in 0.01 steps
Decay multiplier relative to the Master Decay, for the frequencies above the Lo
Xover and below the Mid Xover settings.
Hi Mid Decay
Range: 0.01 to 2.50 in 0.01 steps
Decay multiplier relative to the Master Decay, for the frequencies above the Mid
Xover and below the Hi Xover settings.
Note: This parameter is normally set to 1.0, as it is the main parameter adjusted
by the main decay parameter. This mid-range decay control would normally
be omitted, however, TC Engineers felt you could use this parameter as a ne
adjustment tool to “tweak” a preset to sound just right without having to adjust
the master decay parameter
Hi Decay
Range: 0.01 to 2.50 in 0.01 steps
Decay multiplier relative to the Master Decay, for the frequencies above the
Hi Xover settings.
Lo Xover
Range: 20 Hz to 1 kHz
Sets the frequency at which the transition from the low to the low-mid
frequencies takes place.
Mid Xover
Range: 20 Hz to 2 kHz
Sets the frequency at which the transition from the low-mid to mid frequencies
takes place.
Hi Xover
Range: 500 Hz to 20 kHz
Sets the frequency at which the transition from the mid frequencies to the high
frequencies takes place.