Manual
11 VSS3 NATIVE User Manual
5.4 Reverb Page
Reverb (green controls)
Reverb Type
Options: Smooth, Natural, Alive, Fast, Alive/Wide, Fast/Wide
Adjust this parameter with the Early Level turned all the way o and the Rev
Level all the way up. Change the type to get a feel of what each one sounds like.
Reverb Width
Options: Mono, Center, Stereo or Wide
With this parameter you can change the width of the diuse eld. The Mono
setting is where the left and right reverb tails are completely identical, the Center
setting opens a bit up in the middle, Stereo is the normal stereo image width,
and Wide covers the outside of the stereo image.
Note: Rev Types 'Fast/Wide' and 'Alive/Wide' have only one width, and the
control is faded out and is not changable.
Lo Cut
Range: 20 Hz to 200 Hz in 1 Hz steps
This adjustable lter allows you to remove low frequencies from the reverb tail.
The Lo Cut frequency can be thought of as a Threshold frequency. The cut will be
performed according to the Lo Damp parameter.
Lo Dampen
Range: -18 dB to 0 dB in 0.5 dB steps.
Adjusts the level of the low frequency damper. Set the frequency using the Lo Cut
control.
Hi Cut
Range: 20 Hz to 20 kHz
Rolls o the top end of the signal as it enters the reverb. Used in conjunction with
Hi Soften and Hi Decay to “darken” a room.
Hi Soften
Range: -50 to +50, 0=Default
High Soften is a special lter used to “soften” the high frequencies of the reverb
diuse eld. This is not a simple Hi Cut lter, but a complex set of lters working
together to remove the frequencies that gives a “brittle” or “harsh” sounding
reverb. Hi Soften is scaled/linked to the Hi Cut and Hi Decay parameters.
Reverb Balance
Range: -80 dB L to +80 dB R, 0=Center
The left/right balance of the Reverb. This allows you to oset the diuse eld
from the normal center position by attenuating the reverb tail level on the right
or left channel.
Diuse
Range: -50 to +50, 0=Default
This parameter gives you more or less diusion than the algorithm designer
intended for the given decay time. For optimum performance, the diusion is
automatically adjusted behind the scenes whenever you change decay times.
This parameter gives you the added control to vary the diusion around this
automatic setting.