GAIN LEVEL VOICE TREBLE INPUT OUTPUT BASS DISTORTION true bypass USER’S MANUAL
Important Safety Instructions 1 Read these instructions. 2 Keep these instructions. 3 Heed all warnings. 4 Follow all instructions. 5 Do not use this apparatus near water. 6 Clean only with dry cloth. 7 Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8 Do not install near heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9 Only use attachments/accessories specified by the manufacturer.
These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses and can radiate radio frequency energy and – if not installed and used in accordance with the instructions – may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
(EN) Introduction Röttweiler Distortion goes the extra mile and delivers an unparalleled sound that will inspire you to riff for days. The all-analog design gives you a unique distortion circuit based on soft clipping – just like real tube amps – for an extremely authentic response and tone. Now, you can get that bone-crushing sound through virtually any amp. Röttweiler Distortion is voiced to burn through any mix.
GAIN LEVEL 1 - Effect on/off (true bypass) VOICE 2 - 1/4 inch mono jack input BASS 3 - 1/4 inch mono jack output TREBLE 4 - Bass control INPUT OUTPUT 5 - Treble control 6 - Gain control 7 - Level control DISTORTION true bypass 8 - Voice selector 9 - Power in (9VDC) 5
Connecting Input jack – 1/4 inch mono jack input. If you run the pedal on battery, we recommend removing the input jack to preserve battery power when you don’t play. Output jack – 1/4 inch mono jack output for connecting to another pedal or directly into an amp or mixer.
The Controls BASS & TREBLE Bass/treble controls. Add bass for more punch or roll off a bit for a tighter sound on big cabinets. Add treble to cut through a dense mix or reduce to aim for a softer tone. GAIN Controls the amount of gain. The range goes from medium metal drive to full punchy cutting metal sounds. Try a medium gain-settings with a crunch amp-channel. LEVEL Sets the overall level.
Changing battery – Unscrew the thumb-screw on the back of the pedal and detach the back-plate. Unmount the old battery and attach the new battery to the battery clip making sure the polarity is correct. Then remount the back-plate. To save battery life, remove the input jack when you don’t play. Batteries must never be heated, taken apart or thrown into fire or water. Only rechargeable batteries can be recharged. Remove the battery when the pedal is not being used for a longer period of time.
Sounds Unique distortion circuit with classic tube-amp characteristics: high headroom, low compression and amazing bottom-end Touch sensitive – control tone and distortion level by pick attack and your guitars volume knob Two-band active EQ with separate bass and treble controls Voice switch for vintage or modern voicing Size & Weight 72 mm x 122 mm x 50 mm - 300 g (excl. battery) Battery 16mA current draw Non-stop playing Carbon: 6.5 hours, Alkaline: 25 hours.
TC Electronic, Sindalsvej 34, DK-8240 Risskov info@tcelectronic.
