User manual

PolyTune Clip English Manual 11
Getting support
Inserting/replacing
the battery
If you need to change the PolyTune Clip battery,
proceed as follows:
– Open the PolyTune Clip hinge so that the bat-
tery compartment on the back is accessible.
– Open the battery compartment.
– Remove the drained battery.
– Insert a full CR2032 lithium battery (20 mm
diameter, 3.2 mm height) into the battery
compartment, with the positive terminal (the
plus pole) facing towards you. I.e., when you
have inserted the battery, you should see the
“+” marker on its bottom.
– Close the battery compartment.
Technical specifications
– Tuning Range:
A0 (27.5Hz) to C8 (4186Hz)
– Tuning Accuracy – Chromatic tuning mode:
±0.5Cent
– Tuning Accuracy – Strobe tuning mode:
±0.02Cent
– Reference Pitch:
A4 = 435 to 445Hz
(adjustable in 1 Hz steps)
– Battery:
CR2032 Li-Mn battery
(battery included)
– Dimensions (W x D x H):
25 x 60 x 28mm / 0.98 x 2.36 x1.1”
– Weight:
32g / 1.13oz.
(including battery)
Due to continuous development, these
specifications are subject to change without
notice.
Getting support
If you still have questions about the product af-
ter reading this manual, please get in touch with
TC Support:
http://tcelectronic.com/support/