LMn Manual
Table Of Contents
Interface and feature reference
LM2n / LM6n Manual 25
is selected, the loudness range for the past 6
seconds is displayed.
Max Loudness Time (Max
Loud. Time) parameter
Parameter settings:
0.4 sec – Momentary (M),
3 sec – Short Term (S)
Use the Max Loudness Time parameter to set
the time window used for measuring Maximum
Loudness.
This parameter can only be edited if the Left De-
scriptor parameter is set to another value than
Max Momentary or Max Short Term.
If Left Descriptor is set to Max Momentary, this
value is set to 0.4, and this setting is grayed out.
If Left Descriptor is set to Max Short Term, this
value is set to 3 sec., and this setting is grayed
out.
Peak Indicator parameter
Parameter range: -12 to +3 dBTP in 0.5 dBTP
steps
Use the Peak indicator parameter to define at
which level the red peak indicator in the top right
corner of the Radar page and the PPM page
should light up.
Surround Channel Order (Surr.Ch.
Order) parameter (LM6n only)
Parameter settings:
– L C R – Ls Rs – LFE (Film)
– L R – C – LFE – Ls Rs (SMPTE/ITU)
– L R – Ls Rs – C LFE (DTS)
Use the Surround Channel Order parameter to
choose in which order the surround channels
should be shown in the PPM view.
Radar Color parameter
Parameter settings: Normal, Desaturated
Use the Radar Color parameter to set the color
scheme for the Radar.
The desaturated color scheme is particularly
useful for users working in film applications (who
usually don’t want a colorful interface to distract
them from the film they are working on).
Fig. 18.: LM2n Radar in desaturated mode
Follow Transport parameter
Parameter settings: On, Off
Use the Follow Transport parameter to define if
measurements should follow the transport con-
trols (Start / Stop / Pause) of your host applica-
tion, or run continuously.
– Off setting: The Radar runs all the time, ex-
cept if manually set to PAUSE mode.
– On: The Radar runs depending on the state of
the host applications transport controls.
Reset on Play parameter
Parameter settings: On, Off
When you set this parameter to On, measure-
ments will be reset when going into Play mode.