LMn Manual
Table Of Contents
Interface and feature reference
LM2n / LM6n Manual 22
Stats page
Fig. 16.: LM6n Stats page
The Stats page gives an overview of essential
descriptors, as described in this section.
Please note that clicking the Reset button will re-
set the meters and the log file. See “Reset but-
ton” on page 16.
Statistics
This is the time (given in days, hours, minutes
and seconds) since the plug-in has been instan-
tiated or since the Reset button has been clicked
for the last time.
Program Loudness (I)
This is the Program Loudness. Use the Loud-
ness Units parameter on the Settings page to
define the unit for this display.
Max Momentary Loudness (M) or
Max Short Term Loudness (S)
The parameter displayed in this line depends on
the setting of the Max Loud. Time parameter on
the Settings page.
– If you set the Max Loud. Time parameter on
the Settings page to “0.4 sec (M)”, the param-
eter is displayed as “Max Momentary Loud-
ness (M)”.
– If you set the Max Loud. Time parameter on
the Settings page to “3 sec (S)”, the param-
eter is displayed as “Max Short Term Loud-
ness (S)”.
Use the Loudness Units parameter on the Set-
tings page to define the unit for this display.
Loudness Range (LRA)
This is the Loudness Range, measured in LU.
True-Peak Max
This is the True-peak Max parameter, measured
in dBFS.
Sliding Loudness [n] seconds
Use the Sliding Loudness Time parameter on the
Settings page to define [n].
Use the Loudness Units parameter on the Set-
tings page to define the unit for this display.
PLR
This is the Peak-to-Loudness Range (PLR), mea-
sured in dB.