Manual Revision 2.1

7
paGe Head
HW & installation
7
frOnT and rear
System 6000 Mainframe Front
Power Key
Switches power On/Off.
PCMCIA slot
For handling of preset banks.
Power On LED
Duringstart-upthisLEDisred.Whentheunitisreadyfor
use,theLEDwillturngreen.
System 6000 Mainframe Rear
I/O Slot - A
I/O Slot - B (AES-8)
DSP Slot
I/O Slot - C
I/O Slots A, B and C
These slots are used for the optional I/O cards ADA 24/96
and AES-8. Slots must be filled consecutively in alphabetic
order.
The System 6000 DSP card fits in the DSP slot only. When
I/O cards are mounted, dip switches on the cards must be
set accordingly. Please see the following page.
AnAES-8cardshouldbeinstalledin“I/OSlotB(AES-8)”
only. If your mainframe rear panel carries a label saying
BUSupdatedyoucaninstalltheAES-8cardyourself
following the instructions on the next of this chapter.
DSP Slot
The System 6000 DSP card is placed in the DSP Slot.
Power In
100-230VAC.50/60Hz-auto-select.
LAN/Ethernet
Connection for external control devices e.g. the TC Icon.
The type is 32 bit PCI Ethernet interface fully compliant
with IEE 802.3u 10/100 Mbps CSMA/CD standards.
Theconnectortypeisa100Base-TRJ-45(CN13)
SMPTE
1/4”connectionforSMPTEsync.Input.
Ground Lift
Use this standard chassis ground lift if you encounter
problems with hum.
MIDI In, Thru and Out
5 pin DIN connectors.
Remote
This connection is for service and test purposes only.
Pedal
General Purpose Input. Connect a TC Master Fader or a
tip to ground switch. Applications vary depending on the
specific algorithm.
Rack-mounting Advice
• TheM6000shouldnotbeplacedinanenvironmentwith
a temperature exceeding 50 degrees Celsius.
• Donotcovertheventilationopeningsonthesidesofthe
frame.
The cooling fan is activated according to the
temperature inside.
Reset (countersunk)
Press and hold this button during boot to reset the frames
IP address to the default setting: 192.168.1.xx*, - where
“xx”isthelasttwodigitsintheframesserialnumber.
*Note-iftheframesserialnumberendson“00”,theIP
address will be: 192.168.1.100,as“00”isnotavalidIP
number in all networks.
Serial Number