Manual
Table Of Contents
- Important safety instructions
- Warning
- About this manual
- Before you get started
- Unpacking and setup
- Software: TC Icon and Loudness Pilot firmware
- Loudness Pilot: An introduction
- Loudness Pilot – Basic concepts and operation
- Loudness Pilot status indicators and ports
- Setting up Loudness Pilot
- Basic operation
- Accessing Loudness Pilot
- Obtaining Loudness Pilot status information
- Setting up audio and syncing
- Loudness Pilot remote control
- Recalling, storing and deleting settings
- Updating Loudness Pilot firmware
- Icon Setup
- ALC2
- LM2 (optional)
- Appendix 1: Links and additional information
- Appendix 2: Loudness Pilot GPI/O page
- Technical specifications
Icon Setup
Loudness Pilot English Manual (2014-10-07) 85
Joystick page
The MIDI Joystick setup page of the TC Icon
software is not required for operating Loudness
Pilot and not described in this manual.
UI page
Fig. 39.: TC Icon software – UI page
TC Icon Window parameter
Use the TC Icon Window parameter to specify if
and where faders should be shown. Three op-
tions are available. Changes on this page will
take effect next time you open the TC Icon soft-
ware.
Faders at bottom setting
Faders will be positioned right below the main
interface. This is the default setting.
Fader at right side setting
One fader will be positioned to the right of the
main interface.
No faders setting
No faders will be shown on screen.
Color page
Fig. 40.: TC Icon software – Color page
Use the parameters on the Color page to define
the TC Icon software’s interface colors.