Manual
Table Of Contents
- Important safety instructions
- Warning
- About this manual
- Before you get started
- Unpacking and setup
- Software: TC Icon and Loudness Pilot firmware
- Loudness Pilot: An introduction
- Loudness Pilot – Basic concepts and operation
- Loudness Pilot status indicators and ports
- Setting up Loudness Pilot
- Basic operation
- Accessing Loudness Pilot
- Obtaining Loudness Pilot status information
- Setting up audio and syncing
- Loudness Pilot remote control
- Recalling, storing and deleting settings
- Updating Loudness Pilot firmware
- Icon Setup
- ALC2
- LM2 (optional)
- Appendix 1: Links and additional information
- Appendix 2: Loudness Pilot GPI/O page
- Technical specifications
Icon Setup
Loudness Pilot English Manual (2014-10-07) 82
This chapter covers screens and parameters of
the TC Icon software not directly related to the
day-to-day operation of your Loudness Pilot.
Accessing the Icon Setup pages
►
If it isn’t already, switch the TC
Icon software to Base mode by
clicking the Icon symbol in the
upper left corner of the window
– see “TC Icon modes: Base and
Device operation” on page 39.
In Base Mode, you will see the
Select, Auto and Setup tabs on
the upper edge of the TC Icon
window.
►
Select Setup.
►
Select one of the pages described in the fol-
lowing sections of this manual.
Info page
On this page, the version number of the currently
installed TC Icon software is displayed.
To update the TC Icon software, please refer to
the “Updating Loudness Pilot software” on page
36 section of this manual.