Manual
Table Of Contents
- Important safety instructions
- Warning
- About this manual
- Before you get started
- Unpacking and setup
- Software: TC Icon and Loudness Pilot firmware
- Loudness Pilot: An introduction
- Loudness Pilot – Basic concepts and operation
- Loudness Pilot status indicators and ports
- Setting up Loudness Pilot
- Basic operation
- Accessing Loudness Pilot
- Obtaining Loudness Pilot status information
- Setting up audio and syncing
- Loudness Pilot remote control
- Recalling, storing and deleting settings
- Updating Loudness Pilot firmware
- Icon Setup
- ALC2
- LM2 (optional)
- Appendix 1: Links and additional information
- Appendix 2: Loudness Pilot GPI/O page
- Technical specifications
Updating Loudness Pilot firmware
Loudness Pilot English Manual (2014-10-07) 78
Pilot. We will assume that you have extracted
the content of the ZIP archive to C:\LP\. If
you have extracted it to another location, you will
have to specify this in the “Common Software
Update Folder” field accordingly (see below).
►
Connect your PC to the Loudness Pilot that
you want to update using an Ethernet cable.
►
Launch the TC Icon software on your PC.
►
In the TC Icon software, select the Loudness
Pilot that you want to update.
►
Go to the Frame / System / Setup / Version
page.
Here, you will find the current software ver-
sion of your Loudness Pilot (shown as “Loud-
ness Pilot SW Version”). Note this version
number.
►
Go to the Frame / System / Setup / Update
page.
►
Click into the “Common Software Update
Folder” field.
►
Enter the path to the folder where the down-
loaded .tca file is located.
Example:
Assuming that…
– your hard disk drive has the letter c:\
– you extracted the downloaded .tca file to
the folder “LP” on the drive root (see pre-
vious steps)
…the correct path would be:
C:\LP\
►
Click Enter. You will be returned to the previ-
ous screen.
The name of the .tca file you downloaded
should now be displayed right under the
“Common Software Update Folder” field.
►
If you want to make sure you have selected
the correct file before applying the update,
you can select the downloaded software file
and click the “File Info” button to display ad-
ditional information.
►
To apply the update, select the downloaded
.tca file and click the “Update SW” button.
►
Confirm that you want to perform the update
by clicking the “Yes” button.
►
A confirmation message will be shown once
the update has been applied.
Click “OK”.
►
Go to the Frame / System / Setup / Version
page and note the updated software version.
! Please note that a folder may contain mul-
tiple .tca files, which will be shown on the
Frame / System / Setup / Update page when
that folder is selected. Be sure to select the
correct file – usually, the most current one.
! If you experience technical problems during
software download or installation, please ask
a person with administrator privileges on this
PC for assistance.