Manual
Table Of Contents
- Important safety instructions
- Warning
- About this manual
- Before you get started
- Unpacking and setup
- Software: TC Icon and Loudness Pilot firmware
- Loudness Pilot: An introduction
- Loudness Pilot – Basic concepts and operation
- Loudness Pilot status indicators and ports
- Setting up Loudness Pilot
- Basic operation
- Accessing Loudness Pilot
- Obtaining Loudness Pilot status information
- Setting up audio and syncing
- Loudness Pilot remote control
- Recalling, storing and deleting settings
- Updating Loudness Pilot firmware
- Icon Setup
- ALC2
- LM2 (optional)
- Appendix 1: Links and additional information
- Appendix 2: Loudness Pilot GPI/O page
- Technical specifications
Recalling, storing and deleting settings
Loudness Pilot English Manual (2014-10-07) 69
The Library concept
The Library gives you access to all settings of
all parameters of the currently selected Loud-
ness Pilot.
The highest organizational level of the Library is
a Bank. A Bank will hold either…
►
50 Scene presets or
►
50 Routing presets or
►
100 Engine presets or
►
100 Meter presets
►
Factory presets vs. user presets
When recalling presets, you will see that there
are two categories of presets: Factory presets
and User presets.
►
Factory presets can only be recalled, but not
overwritten or deleted. If you change a Fac-
tory preset and you want to keep it, you have
to store it as a User preset.
►
User presets can be recalled, edited and
stored, thereby overwriting the previous ver-
sion.