Manual

Loudness Pilot remote control
Loudness Pilot English Manual (2014-10-07) 58
Processing section
Audio processing in your Loudness Pilot can be
controlled via GPI or SDI metadata.
When GPI or SDI metadata are being used to
control the device, a blue LED on the respective
Engine pages will indicate that their features are
remote-controlled.
GPI and SDI buttons
Use these buttons to activate audio processing
remote control via GPI 2 input or incoming SDI
metadata.
Please note that this is a “radio button” set – only
one of them can be active at a time.
SDI is only available with the SDI Metadata li-
cense loaded on a Loudness Pilot with SDI in-
puts and outputs. See “Extending your prod-
uct’s capabilities with optional licenses” on page
121.
“Enable” buttons that control the same function
can be found on the Remote – GPI page (in the
GPI 2 – Processing Control section) and on the
Remote – SDI page.
Current Processing status field
The Current Processing status field shows the
current audio processing details no matter if GPI
or SDI metadata is used for control.
“Normal” display
If “Normal” is displayed, audio-processing is not
remote-controlled, and the unit works as speci-
fied by the current Engine preset.
“N/A” display
“N/A” (“not available”) indicates that the currently
selected function is not available/applicable to
the algorithm currently loaded in the Engine.
“N/A” also indicates that the device is not re-
mote-controlled, and the unit works as specified
by the current Engine preset.
Other displays
All other values shown in the Current Process-
ing status field show which features are currently
controlled via GPI or SDI. The possible values
are a combination of the parameters Function,
Engine and Status as set on the Remote – SDI
or Remote – GPI page in the GPI 2 – Processing
Control section.
When using SDI, the same information is shown
on the Remote – SDI page in the Current Pro-
cessing status field.
Resetting section
GPI can be used to reset audio processing his-
tory, meter history, or both.
When GPI is enabled, blue LEDs on the Engine
and Meter pages’ Reset buttons will indicate that
this feature is remote-controlled.
GPI button
Use this button to enable GPI 3 input for remote
control of the Reset function.
An Enable button that activates the same feature
can be found on the Remote – GPI page in the
“GPI 3 – Resetting”.
Resetting status field
The Resetting status field shows the current Re-
set status, no matter wether if it is controlled by
GPI or not.
“Idle” display
The device is not remote-controlled, or it is wait-
ing for a GPI pulse. See below for details regard-
ing the control pulse.
“Resetting xx” display
When the device receives a GPI pulse, this sta-
tus is shown for one second. The “xx” value is a
combination of Function (audio processing and
meter) and Engine.