Manual
Table Of Contents
- Important safety instructions
- Warning
- About this manual
- Before you get started
- Unpacking and setup
- Software: TC Icon and Loudness Pilot firmware
- Loudness Pilot: An introduction
- Loudness Pilot – Basic concepts and operation
- Loudness Pilot status indicators and ports
- Setting up Loudness Pilot
- Basic operation
- Accessing Loudness Pilot
- Obtaining Loudness Pilot status information
- Setting up audio and syncing
- Loudness Pilot remote control
- Recalling, storing and deleting settings
- Updating Loudness Pilot firmware
- Icon Setup
- ALC2
- LM2 (optional)
- Appendix 1: Links and additional information
- Appendix 2: Loudness Pilot GPI/O page
- Technical specifications
Important safety instructions
Loudness Pilot English Manual (2014-10-07) 3
►
Mains ground must be connected.
►
Norwegian:
Apparatet må tilkoples jordet stikkontakt.
►
Swedish:
Apparaten skall anslutas till jordat uttag.
►
Finnish:
Laite on liitettävä suojakoskettimilla va-
rus-tettuun pistorasiaan.
Caution:
►
You are cautioned that any change or modi-
fications not expressly approved in this man-
ual could void your authority to operate this
equipment.
►
To completely disconnect from AC mains,
disconnect the power supply cord from the
AC receptacle.
►
The mains plug of the power supply shall re-
main readily operable.
►
Danger of explosion if battery is incorrect-
ly replaced. Replace only with the same or
equivalent type.
►
Ventilation should not be impeded by cover-
ing the ventilation openings with items, such
as newspapers, tablecloths, curtains, etc.
►
Only used at altitude not exceeding 2000 m.
Service
►
There are no user-serviceable parts inside.
►
All service must be performed by qualified
personnel.