Manual

Setting up audio and syncing
Loudness Pilot English Manual (2014-10-07) 52
to select the stream that Loudness Pilot should
de-embed/embed audio from and to.
! Please note that when running 3G Level B,
data stream 1 and data stream 2 need to
have the same bit width so Loudness Pilot
can de-embed and process audio. I.e., both
data streams need to contain 8-bit data, or
both data streams need contain 10-bit data).
If the bit widths of the two data streams differ,
Loudness Pilot will not be able to de-embed
and process audio.
Stream 1 setting
The Loudness Pilot will de-embed and embed
two of the up to four available audio groups in
stream 1. This is the default setting which is also
used when Advanced SDI mode has not been
activated.
Stream 2 setting
The Loudness Pilot will de-embed and embed
two of the up to four available audio groups in
stream 2.
Bypass button
Settings: Enabled, Disabled
Use the Bypass button to immediately activate a
hardware bypass of the SDI signal, allowing it to
pass through Loudness Pilot unprocessed.