Manual

Obtaining Loudness Pilot status information
Loudness Pilot English Manual (2014-10-07) 47
Sync indicator
The states and color codes shown here are the
same as those shown by the respective Loud-
ness Pilot Sync LED on the front panel of the
device – see “Sync LED(s) – SDI versions” on
page 25.
Alert indicator
The states and color codes shown here are the
same as those shown by the respective Loud-
ness Pilot Alert LED on the front panel of the de-
vice– see “Alert LED” on page 25.
Frame Identification parameter
If you are operating a complex system with mul-
tiple Loudness Pilot units, you may need to iden-
tify one specific unit quickly. To do so, select the
respective Frame using TC Icon software and
then use the Frame Identification parameter to
have that Frame identify itself with blinking Alert
LEDs as follows:
“Off” setting
This is the default setting. The Alert LED oper-
ates as described in “Alert LED” on page 25.
“Green/Off”, “Yellow/Off”, “Red/Off”, “Green/
Yellow”, Green/Red”, “Yellow/Red”
The Alert LED on the front panel of the respec-
tive Frame will blink in the chosen color/color
combination, while the Alert indicator field will
read “LED blinking”.
Signal indicator
The states and color codes shown here are the
same as those shown by the respective Loud-
ness Pilot Signal LED on the front panel of the
device– see “Signal LED” on page 26.