Manual
Table Of Contents
- Important safety instructions
- Warning
- About this manual
- Before you get started
- Unpacking and setup
- Software: TC Icon and Loudness Pilot firmware
- Loudness Pilot: An introduction
- Loudness Pilot – Basic concepts and operation
- Loudness Pilot status indicators and ports
- Setting up Loudness Pilot
- Basic operation
- Accessing Loudness Pilot
- Obtaining Loudness Pilot status information
- Setting up audio and syncing
- Loudness Pilot remote control
- Recalling, storing and deleting settings
- Updating Loudness Pilot firmware
- Icon Setup
- ALC2
- LM2 (optional)
- Appendix 1: Links and additional information
- Appendix 2: Loudness Pilot GPI/O page
- Technical specifications
Accessing Loudness Pilot
Loudness Pilot English Manual (2014-10-07) 44
Scanning / rescanning a
network for devices
The scenario described above covers the first
time you boot up your system or when no con-
nected units are assigned.
When…
►
you make changes to your setup,
►
when devices are powered up or down, or
►
if there are connection errors, these may not
be detected immediately.
In this case, you should scan the network again.
To scan a network for devices:
►
In the TC Icon software, go to Setup / Devices
►
Click the Detect button.
For further information, see “Devices page” on
page 83.
In the following sections of this manual, we as-
sume that you are operating a basic system with
only one Loudness Pilot connected.