Manual
Table Of Contents
- Important safety instructions
- Warning
- About this manual
- Before you get started
- Unpacking and setup
- Software: TC Icon and Loudness Pilot firmware
- Loudness Pilot: An introduction
- Loudness Pilot – Basic concepts and operation
- Loudness Pilot status indicators and ports
- Setting up Loudness Pilot
- Basic operation
- Accessing Loudness Pilot
- Obtaining Loudness Pilot status information
- Setting up audio and syncing
- Loudness Pilot remote control
- Recalling, storing and deleting settings
- Updating Loudness Pilot firmware
- Icon Setup
- ALC2
- LM2 (optional)
- Appendix 1: Links and additional information
- Appendix 2: Loudness Pilot GPI/O page
- Technical specifications
Loudness Pilotstatus indicators and ports
Loudness Pilot English Manual (2014-10-07) 29
Unbalanced AES-3id In Ports
The Unbalanced AES version of Loudness Pilot
has 8 AES-3id In ports on BNC connectors with
one channel pair per connector.
The SDI versions of Loudness Pilot have no AES
In ports.
Unbalanced AES-3id Out Ports
The Unbalanced AES version of Loudness Pilot
has 8 AES-3id Out ports on BNC connectors
with one channel pair per connector.
The SDI versions of Loudness Pilot have no AES
Out ports.
Fig. 17.: Loudness Pilot AES (unbalanced
version) back panel connectors
Balanced AES In/Out Ports
The Balanced AES version of Loudness Pilot
have two Sub-D AES I/O connectors, with chan-
nels 1-8 on the upper connector and channels
9-16 on the lower connector.
The SDI versions of Loudness Pilot have no AES
I/O ports.
Fig. 18.: Loudness Pilot AES (balanced
version) back panel connectors