Manual

Loudness Pilotstatus indicators and ports
Loudness Pilot English Manual (2014-10-07) 26
Signal LED
The Signal LEDs indicate if audio streams are re-
ceived and processed by Loudness Pilot.
Detection for the Signal LEDs and GPO occurs
at the input.
LED color /
indication
Status
Off No audio signal (above
-70dBFS) has been detected.
Green An audio signal above
-70dBFS has been detected.
Yellow An audio signal above -1dBFS
has been detected.
Front panel reset button
The Reset button on the front panel can be used
to reset the IP address of a Loudness Pilot unit or
to reset Ethernet communication between Loud-
ness Pilot and a computer when a communica-
tion error has occurred.
Resetting the IP address of
a Loudness Pilot unit
It may be necessary to reset the IP address of
a Loudness Pilot unit. To do so, proceed as fol-
lows:
►
Switch off Loudness Pilot by disconnecting
both power supplies.
►
Insert a straightened paper clip or a similar
object into the “Reset” hole on the front panel
until it touches the button behind the panel.
►
Boot the Loudness Pilot by connecting one
or both power supplies while still holding the
straightened paper clip onto the Reset but-
ton.
Loudness Pilot will boot using its default IP
address. The default IP address is 192.168.1.[xx],
where [xx] is the last two digits of the device’s
serial number as printed on its back.