Manual

Loudness Pilotstatus indicators and ports
Loudness Pilot English Manual (2014-10-07) 25
Sync LED(s) – SDI versions
Loudness Pilot has three Sync LEDs – one for
each of the up to three cards/engines in the de-
vice. If only one card is installed, only the first
LED will be used.
The Sync LEDs indicate if synchronization to
the currently connected signal source has been
achieved.
LED color /
indication
Status
Off Startup – no lock achieved.
Green An SDI stream has been de-
tected at the corresponding
input, and Loudness Pilot is
locked to it.
Yellow There is an SDI anomaly.
Red Loudness Pilot cannot lock to
the SDI audio stream.
Sync LED(s) – AES versions
The Sync LED of Loudness Pilot AES (balanced/
unbalanced) indicates if synchronization to the
signal source selected as Sync Source has been
achieved.
For a description of all Sync states, see “AES In-
put State indicators” on page 53.
LED color /
indication
Status
Off Startup – no lock achieved /
lock status unknown.
Green A clock signal has been de-
tected at the corresponding
AES input, and Loudness Pilot
is locked to it.
Yellow Loudness Pilot is following its
internal clock or set to Bypass.
Red No lock or Freewheel status
Alert LED
Loudness Pilot has three Alert LEDs – one for
each of the up to three cards/engines in the de-
vice. If only one card is installed, only the first
LED will be used.
The Alert LEDs indicate problems either within
the device or with the signal being processed.
LED color /
indication
Status
Off Loudness Pilot is not connect-
ed to a computer running the
TC Icon software or a hard-
ware TC Icon.
Green Loudness Pilot is connected
to a computer running the TC
Icon software or a hardware
TC Icon. Normal operation, no
problems detected.
Green – blink-
ing
Preset recall
Yellow There has been silence for
more than five seconds, or
the LM2/LM6 algorithm has
detected a “High Loudness”
state.