Manual
Table Of Contents
- Important safety instructions
- Warning
- About this manual
- Before you get started
- Unpacking and setup
- Software: TC Icon and Loudness Pilot firmware
- Loudness Pilot: An introduction
- Loudness Pilot – Basic concepts and operation
- Loudness Pilot status indicators and ports
- Setting up Loudness Pilot
- Basic operation
- Accessing Loudness Pilot
- Obtaining Loudness Pilot status information
- Setting up audio and syncing
- Loudness Pilot remote control
- Recalling, storing and deleting settings
- Updating Loudness Pilot firmware
- Icon Setup
- ALC2
- LM2 (optional)
- Appendix 1: Links and additional information
- Appendix 2: Loudness Pilot GPI/O page
- Technical specifications
Software: TC Icon and Loudness Pilot firmware
Loudness Pilot English Manual (2014-10-07) 16
►
Launch TC Icon by double-clicking the ap-
plication.
TC Icon will try to establish connections to all
connected TCdevices on a local network, in-
cluding your Loudness Pilot.
If a connection cannot be established, please
refer to “Networking basics and trouble-
shooting” on page 32.
If you experience technical problems during
software download or installation, please ask a
person with administrator privileges on this com-
puter for assistance.
Updating TC Icon software
To update the TC Icon software on your comput-
er when a newer version is released,
►
quit the TC Icon software if it currently run-
ning on your Mac,
►
download and extract the newer version as
described in this section and
►
replace the currently installed version by
copying the newer version over it.