Manual
Table Of Contents
- Important safety instructions
- Warning
- About this manual
- Before you get started
- Unpacking and setup
- Software: TC Icon and Loudness Pilot firmware
- Loudness Pilot: An introduction
- Loudness Pilot – Basic concepts and operation
- Loudness Pilot status indicators and ports
- Setting up Loudness Pilot
- Basic operation
- Accessing Loudness Pilot
- Obtaining Loudness Pilot status information
- Setting up audio and syncing
- Loudness Pilot remote control
- Recalling, storing and deleting settings
- Updating Loudness Pilot firmware
- Icon Setup
- ALC2
- LM2 (optional)
- Appendix 1: Links and additional information
- Appendix 2: Loudness Pilot GPI/O page
- Technical specifications
Technical specifications
Loudness Pilot English Manual (2014-10-07) 131
Control Interface
GPI, control inputs (D-SUB) 4 multi-state, multi-function. 0 V to 3.3V DC sensing
GPO output (D-SUB) 2 relays, floating, 200 mA / 24 V AC/DC max
Output voltage (D-SUB) 3.3 V DC, 100 mA current limited
Ethernet and remote control 2 ports, 10/100 Mbits/s, Base-T, SNMP-enabled