Quick Start Guide
TC Electronic
JUNE-60 V2 CHORUS
Authentic Recreation of the Juno-60
Synthesizer Chorus with 2-Button Interface
and BBD Circuitry
Quick Start Guide
Controls and Connectors
(1)
Input/Output jacks – Connect a ¼" TS cable from your
guitar to the INPUT jack.
Mono setup: Set slider to MONO and connect a ¼"
TS cable from the OUTPUT jack to your amplier.
Stereo setup: Set slider to STEREO and connect a
¼" TRS split cable from the OUTPUT jack to a pair
of ampliers.
Note: Input impedance has two options designed to optimize
performance for guitar or keyboard. Access the internal INPUT
LEVEL slide switch (SW6) to choose the optimal option for
your setup
(2)
9 V DC – Connect a standard 9 V power supply
(not included).
(3)
Footswitch – Turns the eect on and o. The LED will
light when the pedal is engaged. The pedal operates in
true bypass when disengaged.
(4)
Mode – Press button I or II to select between 2 chorus
preset settings. Press buttons I and II simultaneously to
activate a 3rd chorus preset setting.
Note: Preset I and II LFO speeds can be changed independently
via the internal LFO SPEED DIP switch (SW5).
SLOW = Original JUNO settings (recommended for keyboards)
FAST = Original JUNE 60 settings (recommended for guitar)
Settings I II III (I+II)
SLOW
0.5 Hz 0.83 Hz
10 Hz
FAST
1.3 Hz 2.2 Hz
(5)
Mono/Stereo switch – Select between MONO and
STEREO mode.
Internal Option Switches
(6)
INPUT LEVEL – Select between input impedance for
GUITAR or KEYBOARD.
(1)
LFO SPEED – Select FAST or SLOW for preset I and/or II.
Battery Replacement
Storage
(3)
(1)
(4)
(5)
(2)
(2)
(1)
V 1.0