Manual

94 FINALIZER Desktop Application User Manual
16.3 Regions in Reference Tracks
If you are working on the chorus in the source track and want to compare it to a chorus in the reference le only, it is very useful to set a region in the reference track
that can be played back looping.
• The selection or creation of a region for a reference track is done in the same way as the A/B track: click and drag in the top section of the Timeline Display.
• The region start and stop times will then be shown in the Project Settings area as mentioned above, and these times will vary if you adjust the times by dragging
the left or right of the region in the timeline display.
• Note that each of the reference tracks can have a dierent region.
16.4 Reference Track Trim
The manual REF Track Trim gain can be used to compare your work against a reference track at equal perceived level. The reference track can also be aligned
automatically with your le by enabling Loudness in the Monitor section.
• Each reference track can be adjusted in level from –10.0 dB to +10.0 dB, using the REF Track Trim area of the Project Settings menu.
• The Trim is only available when the Loudness Compensation is turned o in the Monitor Output section.
• Note that each of the reference tracks can have a dierent trim level.
• The Trim for the selected REF track can also be adjusted using the trim area at the bottom of the Main REF Meter display. (There is just one trim, but it can be
adjusted from two areas for convenience.)