Manual

84 FINALIZER Desktop Application User Manual
14. Master Meter
The master meter section includes a combination of real-time metering as well as constantly updated full track measurements.
The B meter always reects what goes into the Output File and not what goes to your monitors, which could be aected by audition settings, for example Band Solo in
multiband compressors.
• Real-time True-Peak PPM meters, with high resolution near the top, for A (source), and B (processed le) or REF les. They include peak-hold lines and readouts.
• Real-time Short-term Loudness meters for A (source) and B (processed le or REF les). They include peak-hold lines and readouts.
• The boxes show the constantly updated full track signal descriptors: Track Loudness, True-Peak Max and PLR (Peak-to-Loudness ratio). The PLR is reected by a
white clamp as well.
• At the bottom there is a shortcut to either the Limiter Gain parameter or the output Loudness value, depending on which Limiter type is used. When in
REF Compare mode the shortcut will be the selected track’s REF Track Trim gain adjustment. This adjustment will be disabled if Loudness is enabled in the
Monitor section.
The example below shows a typical A (source le) meter display of two PPM meters in yellow, and the Loudness meter in blue, next to the Prepare Edit View
for comparison:
Note that the Prepared Track Loudness value and True-Peak Maximum are shown in the meter display as well as the Prepare EDIT View.