Manual

44 FINALIZER Desktop Application User Manual
3 Band, TC Legacy, compressor modules (abbreviation = 3C)
The example below is one of the 3 band compressor modules. Note that all the factory supplied 3 band compressor module presets have the same controls as shown,
just at dierent adjustment settings.
The 3 band compressor modules have the following controls:
• Linking/unlinking of Threshold (T), Ratio (R), Gain (G), Attack, and Release controls between bands
• Crossover Frequency (X) for low crossover and high crossover
• Threshold (T)
• Ratio (R)
• Gain (G)
• Attack
• Release
• Makeup gain on/o
• Band Solo on/o
Linking/unlinking of Threshold (T), Ratio (R), Gain (G), Attack, and Release
The 3 band compressor modules allow parameters to be linked as follows:
• Adjusting the Threshold (T) in one band will adjust the Threshold in the other bands.
• Adjusting the Ratio (R) in one band will adjust the Ratio of the other bands.
• Adjusting the Gain (G) in one band will adjust the Gain of the other bands.
• Adjusting the Attack or Release times in one band will adjust them in the other bands.
Linking/unlinking procedure:
• In the top left corner of the SPECTRO LAB display is a link/unlink button. (It only works in the 3 band or 5 band compressor modules.)
• Press this button to link these controls between bands. (The link button will be slightly highlighted when on).
• If the controls are linked, then dragging one gain (G) control, for example, will move all 3 gain controls.
• Press this button again to unlink these controls between bands, so the parameters can be adjusted independently in each band.
• As a further clue to whether the controls are linked, if all three Control Sticks / bands are highlighted (that is 3C L, 3C M, and 3C H) and control balls are shown,
then they are linked.
Note:
• Shortcut: Ctrl (Win) / CMD (Mac) + l will link or unlink all bands.