Manual
Table Of Contents
- Important Safety Instructions
- 1. Introduction
- 2. Getting Started
- 3. Top Bar
- 4. Top Menu
- 5. Compare
- 6. SPECTRO LAB
- 7. Processing Modules
- 8. Processing Chain
- 9. Module List
- 10. Library
- 11. Edit View
- 12. Algorithms in depth
- 13. Monitor Output
- 14. Master Meter
- 15. Timeline
- 16. Reference Tracks
- 17. Preferences Menu
- 18. Project and Audio files
- 19. Specifications
18 FINALIZER Desktop Application User Manual
EQ Curve Overlay Toggle
The EQ curve corresponding to the EQ modules (not the dynamic modules) can be shown as an overlay on top of the SDC. To always see the EQ curve overlaid on the
graph, select the button in the top left corner of the graph as shown. Select the button again to turn the overlay o. This button is not available in REF mode, or if the
selected Module does not feature an overlay.
When the EQ overlay is on, the EQ curve will be displayed and remain, as shown in the example below. Note: If this EQ overlay is o, the EQ curve will be shown
momentarily if the mouse is moved close to the EQ controls (BL, G, and BW in this example).
In the example below, the Dierence button is on, and so is the EQ overlay. The thicker lled areas show exactly the spectral and dynamic changes between the
prepared source A and processed B, caused by the application of the Bell Damp Mids module. All SDC curves are aected equally, as the EQ will aect all signal levels
(as opposed to a dynamic module).