DITTO-X4-LOOPER Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- 1. Introduction
- 2. Setup
- Recording a single loop
- Overdubbing
- Undo
- Redo
- Using undo/redo creatively
- Stopping loop playback/recording
- Stopping loop playback/recording and deleting the loop
- Deleting the loop when you are not recording or playing back
- Using two loops in Serial mode
- Using two loops in Sync mode
- Current (in-memory) loop vs. stored loop (backing track)
- Current loop stays in memory
- USB operation vs. looping
- Exporting Ditto X4 Looper loops to a computer
- About audio formats
- Importing loops into Ditto X4 Looper from a computer
- Importing MP3 files to Ditto X4 Looper
- Balancing backing track and current loop levels
- Reverse
- Half
- Once
- Tape Stop
- Fade
- Double
- Hold
- Multiple FX
- Switch 1
- Switch 2
- Switch 3
- Switch 4
- Preparing the firmware update
- Applying the firmware update
- 1. Introduction
