DITTO-X4-LOOPER Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- 1. Introduction
- 2. Setup
- Recording a single loop
- Overdubbing
- Undo
- Redo
- Using undo/redo creatively
- Stopping loop playback/recording
- Stopping loop playback/recording and deleting the loop
- Deleting the loop when you are not recording or playing back
- Using two loops in Serial mode
- Using two loops in Sync mode
- Current (in-memory) loop vs. stored loop (backing track)
- Current loop stays in memory
- USB operation vs. looping
- Exporting Ditto X4 Looper loops to a computer
- About audio formats
- Importing loops into Ditto X4 Looper from a computer
- Importing MP3 files to Ditto X4 Looper
- Balancing backing track and current loop levels
- Reverse
- Half
- Once
- Tape Stop
- Fade
- Double
- Hold
- Multiple FX
- Switch 1
- Switch 2
- Switch 3
- Switch 4
- Preparing the firmware update
- Applying the firmware update
- 1. Introduction
13 Ditto X4 Looper User Manual
10. Specications
Bypass mode True Bypass (Buered Bypass optional)
Signal circuitry Analog dry-through
Dimensions (W x D x H) 235 x 145 x 57mm (9.3 x 5.7 x 2.2")
Input connector 2 Standard ¼” jacks – mono/TS with
automatic mono/stereo sensing
Input impedance 1MΩ
Output connector 2 Standard ¼” jacks – mono/TS with
automatic mono/stereo sensing
Output impedance 100Ω
Power input Standard 9V DC, centre negative
>300mA (power supply included)
MIDI IN + MIDI THRU Standard 5 Pin DIN connectors
USB port Mini USB connector for le transfers
and for software updates