Manual

Operation – Rear Panel

BH550 / BH800 English Manual (2014-10-02) 15

This section describes the rear panel ports and controls of your bass amp from left to right.

The descriptions apply to both BH550 and BH800 – the only difference between these amps is their power.

9. MAINS IN – Power

switch & Power input

The switched-mode power supply of this de-

vice accepts voltages from 100V to 240V. The

ground pin of the power supply unit must always

be connected in order to avoid voltage differ-

ences between e.g. the PA and your bass amp.

10. SPEAKER OUT jack

Use the SPEAKER OUT connector for connect-

ing your amp to speaker cabinets.

Please note that this is a speakON connector,

and you must use speaker cables for connect-

ing the amp to your cabinets. Do not use instru-

ment cables!

Use a cabinet configuration with your BH550/

BH800 with a minimum load of 4Ohms.

11. PEDAL input jack

You can connect a TC Electronic Switch-3 to the

PEDAL input of your bass amp to control the fol-

lowing features:

1: Activate TonePrint A

2: Activate TonePrint B

3: Mute on/off.

For more information about Switch-3, see

tcelectronic.com/switch-3/