Use and Care Manual

9
INSTALLATION INSTRUCTIONS
Before using your beverage cooler
Remove the exterior and interior packing.
Check to be sure you have all of the following parts:
o shelves
o Instruction Manual
will reduce the possibility of a malfunction in the cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Installation of your beverage cooler
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or grounding should be directed toward a certified electrician or an authorized Products service center
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme
cold ambient temperatures may also cause the unit not to perform properly.
Avoid locating the unit in moist areas.
This appliance is designed to be for f
ree standing installation or flush-in.
Direct
.
Electrical connection

Warning

: Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized service center.
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a
three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock.
Do not under any circumstances cut or remove the third ground prong from the powe
r cord supplied. For personal
safety, this appliance must be properly grounded.
This appliance requires a standard 115V/60Hz electrical ground outlet with three-prong. Have the wall outlet and
circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a standard 2-prong
wall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded
3-prong wall outlet. The cord should be secured behi
nd the appliance and not left exposed or dangling to prevent
accidental injury.
-
-
-
Before connecting the beverage cooler to the power source, let it stand upright for approximately 2 hours. This
-
-
-
Place your beverage cooler on a floor that is strong enough to support it when it is fully loaded.
To level your
-
Locate the beverage cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
-
beverage cooler, adjust the front leveling legs at the bottom of the beverage cooler
-
Plug the beverage cooler into an exclusive, properly installed-grounded wall outlet. Do not under any
.
o
2 Keys