Owner's manual
TW-407 Rev.-
5
Extreme Cold - Cover Eyes and Exposed Skin
Accidental contact of liquid oxygen or cold issuing gas with the skin or eyes may
cause a freezing injury similar to frostbite. Handle the liquid so that it won’t
splash or spill. Protect your eyes and cover the skin where the possibility of
contact with the liquid, cold pipes and equipment, or the cold gas exists. Safe-
ty goggles or a face shield should be worn if liquid ejection or splashing may
occur or cold gas may issue forcefully from equipment. Clean, insulated gloves
that can be easily removed and long sleeves are recommended for arm protec-
spilled liquid. If clothing should be splashed with liquid oxygen or otherwise
saturated with the gas, air out the clothing immediately, removing it if possible.
-
ed oxygen remains, and should not be considered safe for at least 30 minutes.
Replacement Parts Must be Suitable for Oxygen Service
Many materials, especially some non-metallic gaskets and seals, constitute a com-
bustion hazard when in oxygen service, although they may be acceptable for
use with other cryogenic liquids. Make no substitutions for recommended spare
parts. Also, be sure all replacement parts are thoroughly “Cleaned For Oxygen
Service” in accordance with Compressed Gas Association (CGA) Pamphlet G-4.1
Observe Safety Codes When Locating Oxygen Equipment
Before locating oxygen equipment, become thoroughly familiar with National
Fire Protection Association (NFPA) Standard No. 50, “Bulk Oxygen Systems”,
and with all federal, state and local safety codes. The NFPA Standard covers the
general principles recommended for the installation of bulk oxygen systems on
industrial and institutional consumer premises.
Safety Precautions for Liquid Nitrogen and Liquid Argon
Extreme Cold - Cover Eyes and Exposed Skin
Accidental contact of liquid nitrogen or cold issuing gas with the skin or eyes
may cause a freezing injury similar to frostbite. Handle the liquid so that it won’t
splash or spill. Protect your eyes and cover the skin where the possibility of con-
tact with the liquid, cold pipes and equipment, or the cold gas exists. Safety gog-
gles or a face shield should be worn if liquid ejection or splashing can occur or
cold gas can issue forcefully from equipment. Insulated gloves that can be easily
removed and long sleeves are recommended for arm protection. Trousers with-
Liquid nitrogen is obtained by cooling air until it becomes a liquid and then removing the oxygen.
atmospheric pressure.
NOTE: Argon is an inert gas whose physical properties are very similar to those of Nitrogen. For
handling of liquid Argon, follow the safe practices described for the handling and use of liquid Nitrogen.
WARNINGS