Owner manual

Specifications
5HIULJHUDWRU &3 &3 &3 &3
6WDWLF+ROGLQ
J
7LPH GD
\
V GD
\
V GD
\
V GD
\
V
:RUNLQ
J
7LPH GD
\
V GD
\
V GD
\
VGD
\
V
(YDSRUDWLRQ5DWH /GD\ /GD\ /GD\ /GD\
/1&DSDFLW\ /LWHUV /LWHUV /LWHUV /LWHUV
$EVRUEHG/1&DSDFLW\ /LWHUV /LWHUV /LWHUV /LWHUV
(P
S
W
\
:HL
J
KW 

ZRFDQLVWHU

OEN
J
OEN
J
OEN
J
OEN
J
)XOO:HLJKW ZRFDQLVWHU
DQGHP
S
W
\
ZHOO
OEN
J
OEN
J
OEN
J
OEN
J
1HFN'LDPHWHU LQPP LQPP LQPP LQPP
2YHUDOO+HLJKW
LQPP LQPP LQPP LQPP
2YHUDOO'LDPHWHU
LQPP LQPP LQPP LQPP
1XPEHURI&DQLVWHUV    
&DQLVWHU'LDPHWHU
LQPP LQPP LQPP
LQ[LQER[

QRPLQDO

6WRUDJH&DSDFLW\
POYLDOV
FFVWUDZV
POYLDOV
FFVWUDZV
POYLDOV
FFVWUDZV
POYLDOV
RUEORRGED
J
V
)RRWQRWHV
%DVHGRQVWDWLFQLWURJHQHYDSRUDWLRQRIDOLTXLGIXOOFRQWDLQHU
%DVHGRQDEVRUEHGQLWURJHQFDSDFLW\HPSW\FDQLVWHUZHOO
:HLJKWVPD\YDU\VOLJKWO\IRUHDFKFRQWDLQHU7RYHULI\)XOO:HLJKWDQGZKHWKHU\RXUXQLWLV
FRPSOHWHO\FKDUJHGZHLJK\RXUXQLWHPSW\%\DGGGLQJWKH$EVRUEHG/1ZHLJKWR\RXUHPSW\ZHLJKW
\RXZLOONQRZH[DFWO\ZKDW\RXUIXOO\FKDUJHGXQLWVKRXOGZHLJK
)HQZDO5RU5
PP
J
REOHWVRQFDQHVWZROHYHOV
Routine Care & Maintenance
DO NOT attempt to fasten any device to the container.
Welding, brazing piercin of the container in any matter, or
putting liquid other than nitrogen into the container will
result in permanent damage.
Refrigeration depends on the presence of cryogenic
nitrogen refrigerant in the refrigerator. Be sure to fully
charge the refrigerator with refrigerant to prevent loss of
stored material. Please refer to the Operation selection
of this document for instruction for filling procedure. If you
are not able to fully charge the CryoPak by weight, it is
possible that moisture has accumulated in the filler
material over time with normal useage. This accumulation
will result in displacement of refrigerant. Allow the refrig-
erator to warm to room temperature. The warming proce-
dure may take as long as four weeks. Then direct dry heat
not to exceed 150°F (65°C) (from hair dryer or other source)
into the refrigerator. The unit is acceptably dry when the tare
weight is within 1 lb. (0.45 kg) of the as received from the
manufacturer tare weight.
If high evaporation rates are apparent under normal operat-
ing conditions, the refrigerant may be losing its vacuum.
Sweating of freezing of the outside casing are definite
indications that the vacuum integrity is not normal. Read the
Handle with Care booklet (form number TW-10) supplied
with the shipper for more information on the proper handling
of your cryogenic refrigerator.
DO NOT fill the CryoPak containers with any other liquid
other than liquid nitrogen.
NOTE: Specifications are based on vertical storage. Evaporation rates and working time will be effected by manufac-
turing tolerances and temperature of material being stored and other variables unseen. Specifcations are subject to
change without notice.