Integration Manual
Table Of Contents
- Contents
- 1 System description
- 1.1 Overview
- 1.2 Architecture
- 1.3 Pin-out
- 1.4 Operating modes
- 1.5 Supply interfaces
- 1.5.1 Module supply input (VCC)
- 1.5.1.1 VCC supply requirements
- 1.5.1.2 VCC current consumption in 2G connected mode
- 1.5.1.3 VCC current consumption in 3G connected mode
- 1.5.1.4 VCC current consumption in LTE connected mode
- 1.5.1.5 VCC current consumption in cyclic low power idle mode / active mode
- 1.5.1.6 VCC current consumption in fixed active mode
- 1.5.2 Generic digital interfaces supply output (V_INT)
- 1.5.1 Module supply input (VCC)
- 1.6 System function interfaces
- 1.7 Antenna interfaces
- 1.8 SIM interfaces
- 1.9 Data communication interfaces
- 1.10 eMMC interface
- 1.11 Digital Audio interfaces
- 1.12 ADC interfaces
- 1.13 General Purpose Input/Output
- 1.14 Reserved pins (RSVD)
- 1.15 System features
- 1.15.1 Network indication
- 1.15.2 Jamming detection
- 1.15.3 IP modes of operation
- 1.15.4 Dual stack IPv4 and IPv6
- 1.15.5 Embedded TCP/IP and UDP/IP
- 1.15.6 Embedded FTP and FTPS
- 1.15.7 Embedded HTTP and HTTPS
- 1.15.8 SSL and TLS
- 1.15.9 Firmware update Over AT (FOAT)
- 1.15.10 Firmware update Over The Air (FOTA)
- 1.15.11 Power Saving
- 2 Design-in
- 2.1 Overview
- 2.2 Supply interfaces
- 2.2.1 Module supply (VCC)
- 2.2.1.1 General guidelines for VCC supply circuit selection and design
- 2.2.1.2 Guidelines for VCC supply circuit design using a switching regulator
- 2.2.1.3 Guidelines for VCC supply circuit design using a LDO linear regulator
- 2.2.1.4 Guidelines for VCC supply circuit design using a rechargeable battery
- 2.2.1.5 Guidelines for VCC supply circuit design using a primary battery
- 2.2.1.6 Additional guidelines for VCC supply circuit design
- 2.2.1.7 Guidelines for the external battery charging circuit
- 2.2.1.8 Guidelines for external charging and power path management circuit
- 2.2.1.9 Guidelines for removing VCC supply
- 2.2.1.10 Guidelines for VCC supply layout design
- 2.2.1.11 Guidelines for grounding layout design
- 2.2.2 Generic digital interfaces supply output (V_INT)
- 2.2.1 Module supply (VCC)
- 2.3 System functions interfaces
- 2.4 Antenna interface
- 2.5 SIM interfaces
- 2.6 Data communication interfaces
- 2.7 eMMC interface
- 2.8 Digital Audio interface
- 2.9 ADC interfaces
- 2.10 General Purpose Input/Output
- 2.11 Reserved pins (RSVD)
- 2.12 Module placement
- 2.13 Module footprint and paste mask
- 2.14 Thermal guidelines
- 2.15 Design-in checklist
- 3 Handling and soldering
- 4 Approvals
- 5 Product testing
- 6 FCC Notes
- Appendix
- Glossary
- Related documents
- Revision history
- Contact
TOBY-L3 series - System Integration Manual
TSD-19090601 - R13 Page 3 of 143
Contents
Contents...................................................................................................................................................... 3
1 System description ............................................................................................................................ 7
1.1 Overview ........................................................................................................................................................................................... 7
1.2 Architecture ................................................................................................................................................................................... 12
1.3 Pin-out ............................................................................................................................................................................................. 13
1.4 Operating modes ....................................................................................................................................................................... 22
1.5 Supply interfaces ........................................................................................................................................................................ 25
1.5.1 Module supply input (VCC) ......................................................................................................................................... 25
1.5.2 Generic digital interfaces supply output (V_INT) .............................................................................................. 32
1.6 System function interfaces ..................................................................................................................................................... 33
1.6.1 Module power-on ............................................................................................................................................................ 33
1.6.2 Module power-off ............................................................................................................................................................ 35
1.6.3 Module reset ...................................................................................................................................................................... 37
1.6.4 Module / host configuration selection .................................................................................................................. 38
1.7 Antenna interfaces ..................................................................................................................................................................... 39
1.7.1 Antenna RF interfaces (ANT1 / ANT2) ................................................................................................................... 39
1.7.2 Antenna detection interface (ANT_DET) ................................................................................................................ 41
1.8 SIM interfaces............................................................................................................................................................................... 41
1.8.1 SIM interfaces .................................................................................................................................................................... 41
1.8.2 SIM detection interface ................................................................................................................................................. 42
1.9 Data communication interfaces ........................................................................................................................................... 42
1.9.1 USB interface ...................................................................................................................................................................... 43
1.9.2 UART interfaces ................................................................................................................................................................. 44
1.9.3 SPI interfaces ...................................................................................................................................................................... 49
1.9.4 DDC (I2C) interfaces ........................................................................................................................................................ 49
1.9.5 SDIO interface .................................................................................................................................................................... 50
1.9.6 SGMII interface .................................................................................................................................................................. 51
1.10 eMMC interface ........................................................................................................................................................................... 52
1.11 Digital Audio interfaces ........................................................................................................................................................... 53
1.12 ADC interfaces ............................................................................................................................................................................. 54
1.13 General Purpose Input/Output ............................................................................................................................................ 54