Owner's Manual

Connections
En-16
With u (Remote Interactive), you can use the following
special functions:
■ System On/Auto Power On
When you start playback on a component connected via
u, while the AV receiver is on standby, the AV
receiver will automatically turn on and select that
component as the input source.
■ Direct Change
When playback is started on a component connected via
u, the AV receiver automatically selects that
component as the input source.
■ Remote Control
You can use the AV receiver’s remote controller to
control your other u-capable components, pointing the
remote controller at the AV receiver’s remote control
sensor instead of the component. You must enter the
appropriate remote control code first (➔ page 71).
Note
•Use only u cables for u connections. u cables are supplied
with u-capable components.
• Some components have two u jacks. You can connect either
one to the AV receiver. The other jack is for connecting
additional u-capable components.
• Connect only u-capable components to u jacks. Connecting
other manufacturer’s components may cause a malfunction.
• Some components may not support all u functions. Refer to the
manuals supplied with your u-capable components.
• While Zone 2 is on, the System On/Auto Power On and Direct
Change u functions do not work.
Connecting RI Components
1
Make sure that each u-capable component is
connected with an analog audio cable (connection
G
in the hookup examples) (➔ page 15).
2
Make the u connection (see the illustration).
3
If you’re using an RI Dock, or cassette tape deck,
change the Input Display (➔ page 41).
L R
ANALOG
AUDIO OUT
L R
ANALOG
AUDIO OUT
e.g., cassette tape deck
RI Dock