User Manual

8
TASCAM DR-100MKIII
2 – Names and functions of parts
Right side
c Battery compartment (AA batteries)
Install batteries (2 AA) in this compartment to power the
unit. (See “Using AA batteries” on page 14.)
v SD card slot
Insert an SD card here.
b Input level knob
Use this to adjust the input signal volume.
Bottom
n Tripod mounting threads (1/4-inch)
Use to attach this unit to a tripod.
CAUTION
•
Securely tighten all the screws on the tripod or microphone
stand to prevent the unit from falling off.
•
When using this unit attached to a tripod or microphone
stand, place it on a level surface.
•
Some tripods have different screw specifications that make
direct connection impossible. Use a commercially-available
adapter with such tripods.
•
Screws longer than 4.5 mm cannot be attached.
m REC indicator
This functions in the same way as the REC indicator on the
top of the unit.
Home Screen
Stopped/playing
Recording/recording standby
1
Input source
This shows the input source set with the I/O SETTING
screen SOURCE item. (See “Setting recording input sources”
on page 21.)
UNI MIC (built-in directional mic) input
OMNI MIC (built-in omnidirectional mic)
input
MIC/LINE IN jack connected mic input
MIC/LINE IN jack connected line level input
EXT IN jack connected mic input
EXT IN jack connected line level input
DIGITAL IN jack connected digital input
2
Input channel indicator (ST/L/R/MIX)
This shows the REC SETTING screen FILE TYPE item setting.
(See “Recording in mono (file type setting)” on page 21.)
Stereo input/stereo file
Left channel input/mono file
Right channel input/mono file
L-R mix input/mono file
3 Low cut filter on/off status
This icon shows whether the low cut filter is on or off. (See
“Setting the low-cut filter” on page 23.)
Low cut filter off
Low cut filter on (40 Hz)
Low cut filter on (80 Hz)
Low cut filter on (120 Hz)
Low cut filter on (220 Hz)