User Manual

30
TASCAM DR-100MKIII
5 – Playback
Playing recordings
When the Home Screen is open and playback is stopped or
paused, press the PLAY/PAUSE [y/9] button to start playback.
Pausing playback
When the Home Screen is open, press the PLAY/PAUSE [y/9]
or STOP [8] button to pause.
Press the PLAY/PAUSE [y/9] button again to resume playback.
Stopping playback
When the Home Screen is open, press the STOP [8] button
while paused to return to the beginning of the file.
Searching backward and forward
When the Home Screen is open and a track is playing back
or stopped, press and hold the . or / button to search
forward or backward.
Release the button to stop again or resume playback.
NOTE
Press and hold the . or / button to accelerate the
search speed.
Changing the playback position
Turn the wheel while the Home Screen is open when playing,
paused or stopped to move the playback position.
Stop turning the wheel to stop again or resume playback.
Selecting files for playback (skipping)
When the Home Screen is open, press the . and / buttons
to select the file for playback.
Press the . button when in the middle of a file to return to
the beginning of that file. Press the . button when at the
beginning of a file to skip to the beginning of the previous file.
If you press the / button when located at the beginning or
middle of a file, the playback position will skip to the beginning
of the next file.
NOTE
You can also use the browse screen to select files for
playback. (See “6 – Working with Files and Folders” on page
32.)
Repeat playback (LOOP PLAY)
With this function, you can continuously repeat (loop) the
playback of an interval between two points.
1. Press the Fn button to open the FUNCTION screen, and select
the LOOP PLAY item. (See “Basic menu operation procedures”
on page 10.)
2. Turn the loop playback function on.
Options: OFF (default), ON
3. Loop playback mode will be enabled when you return to the
Home Screen.
IN appears in the loop playback status area.
4. During playback or when paused, press the ENTER/MARK
button to set the IN (starting) point.
5. Press the ENTER/MARK button again to set the OUT
(ending) point.