User Manual

TASCAM DR-100MKIII
19
3 – Preparation
Using the built-in speaker for playback
Set the (speaker) switch to ON to listen to playback from the
built-in speaker.
NOTE
Even if the (speaker) switch is set to ON, the speaker will
not output sound when the unit is recording, in recording
standby or connected to headphones.
Connecting monitoring equipment
To listen with an external monitoring system (powered monitor
speakers or an amplifier and speakers), connect it to the LINE
OUT jack.
To listen with headphones, connect them to the (headphone)
jack.
Powered monitor speakers or
amplifier and speakers
Headphones
Adjusting playback volume
Use the (headphone/speaker) LEVEL control to adjust the
volume output from the built-in speaker and (headphone)
jack. (See “Restricting the headphone output level.” on page
44.)
Connecting cameras
When recording video on a camera, this unit can simultaneously
record the same sound as the camera. Connect this unit and the
camera as follows to input sound into the camera.
DSLR camera
External mic input jack
NOTE
When connected to a camera, the line output level can be
attenuated 30 dB. (See “Restricting the line output level” on
page 44.)