User Manual

TASCAM DR-100MKIII
15
3 – Preparation
Using an AC adapter (sold separately)
As shown in the illustration, connect a TASCAM PS-P520E AC
adapter (sold separately) to the unit's USB port and charge the
unit.
AC outlet
Micro-B
USB connector
TASCAM
PS-P520E (sold separately)
NOTE
When the AC adapter is connected, power will be supplied
from the AC adapter. The unit can be used while it is
charging.
CAUTION
Noise may occur when recording with a microphone if the
unit is too close to the AC adapter. In such a case, keep suffi-
cient distance between the AC adapter and the unit.
Using an external battery pack (sold
separately)
Connect a TASCAM BP-6AA external battery pack (designed for
use with this unit and sold separately) to the recorder with a USB
cable (A to Micro-B) as shown in the illustration. For details, see
the BP-6AA Owner’s Manual.
TASCAM BP-6AA (sold separately)
Micro-B
USB connector
CAUTION
The unit cannot detect the remaining battery charge of a
BP-6AA.
Inserting and removing SD cards
CAUTION
•
SD cards that meet SD, SDHC or SDXC standards can be used
with this unit.
•
A list of SD cards that have been confirmed to work with this
unit can be found on our website (http://tascam.com/).
Inserting the card
1. Open the SD card slot cover.
2. Insert an SD Card into the slot as shown in the illustration
until it clicks into place.
3. Close the SD card slot cover.
Removing the card
1. Open the SD card slot cover.
2. Press the SD card in gently and then release it to allow it to
come out.
SD card write protection switches
SD cards have protection switches that prevent writing new
data to them.
If you slide the protect switch to the LOCK position, file recording
and editing will not be possible. Unlock the write-protection in
order to record, erase and otherwise edit data on the card.
Writable Write-protected