User's Guide

Tarvos User Guide - Version 0.3 29
antennas.p.a.conducted_power
Read Permission
admin
Write Permission
admin
Default
270
Priority
3
(Integer) Protocol specific transmit power for antenna port 'a'. Where 'a' can
be between 1 and antennas.port_count. And where 'p' is determined by
the supported protocols of the reader (see setup.valid_protocols).
If antennas.a.conducted_power is used, the protocol specify power
will be replaced.
Example:
antennas.isoc.1.conducted_power=250
ok
antennas.conducted_power_units
Read Permission
admin
Write Permission
admin
Default
NULL
Priority
-1
(Enum) The displayed conducted power units (or advanced computed conducted
power). Its in
either 'cBm' (centibel-milliwatt) or 'mBm' (millibel-milliwatt). On
entry, the conducted power
level is automatically determined. Those above 1000 are considered
milliBels, those below
are considered in centiBels.
2300 mBm == 230 cBm
Example:
antennas.conducted_power_units=cBm
ok
antennas.1.conducted_power
ok 230
antennas.conducted_power_units=mBm
ok
antennas.1.conducted_power
ok 2300