User Manual

7
III.Flight Test
Steps:
Attentions:
Gimbal Self-check:
1. Please ensure all the wirings are correct and the power supply is in great condition.
2. Turn on the transmitter.
3. Powering up the gimbal and keep it still. After self-check, gimbal angle corresponds to
INIT ANGLE in the assistant software.
4. Switch from different working modes to check the rotation direction in ROLL, PITCH,
and PAN axis.
Before flight test, please ensure:
1. After powering up the gimbal, it enters self-check procedure. When RED & BLUE lights
flash twice at the same time, self-check finishes.
2. When self-check finishes, gimbal angles corresponds to INIT ANGLE in the assistant software.
1. Correctly mount the camera into the gimbal and the gimbal onto the multi-rotors.
2. All the wirings are correct.
3. The camera and transmitter have correctly set.
IV. T4-3D Assistant Software
1. Drive & PC Assistant Software Installation and Setup
2. Introduction
①Please download the drive and PC assistant software from
②Run the drive program under USB Driver folder, and finish the installation procedures step by step.
Windows x86: “CP210xVCPInstaller_x86.exe”;
Windows x64: “CP210xVCPInstaller_x64.exe”;
③Connect the USB module to the computer, and finish the installation.
④Run the assistant software ZYXT-3D.EXE and set parameters.
http://www.tarotrc.com/
T4- 3Da three-axis gimbal, could support the camera to stabilize its positions on the roll, tilt and pan axis.
You could adjust receiver type, working mode, angle range and other options in the assistant software.
First of all, please connect gimbal controller to the PC through a USB cable. Choose a correct
COM port and click the “Connect”.
If the connection is successful, the gimbal would stop rotating to protect your device.
After parameters setup finishes, click “Run Gimbal”. Push sticks and toggle switches to
ensure the gimbal works correctly.
When gimbal configuration finishes, you should click "Write Flash" to ensure all the
parameters have written to the gimbal. Next time, the gimbal will automatically run
the parameters you have saved in the flash.
ASSEMBLY SECTION
组装说明书
T4-3d
TA R O T AV I A T I O N T E C H N OL O G Y C O. ,LT D
塔 罗 航 空 科 技 有 限 公 司