User Manual

2. Gimbal Working Mode

You should select a three-positioned or two-positioned switch in R/C for working mode.

Please connect the corresponding port of the receiver to CH1/SBUS or CH2 of the

gimbal controller. Also, set RC MAPPING in the assistant software. For different

positions, use endpoint fine tune function to set. Please refer to the MODE Channel

section in assistant software for detailed information.

Attentions:

Descriptions about working mode:

When the MODE port is unconnected, the gimbal can only work in the DEFAULT mode.

Moreover, during flight, if the MODE is unconnected suddenly, the working mode would

remain the same before disconnection.

After powering up the gimbal, if the receiver is unconnected, it works on DEFAULT MODE.

Pan Follow (PF) Mode

FPV Mode (First Person View)

Descriptions

Tx Control

Attitude Stability

Vibration

Reduction

The angles of Roll and Pitch

keep unchanged, while the

angle of Pan axis changes

according to the head of the

multi-rotor.

Under Control

The angles of Roll, Pitch and Pan

axis change according to the

attitude of the multi-rotor.

3.Working Mode Setup

Choose a two-positioned or three-positioned switch:

Take the three-positioned switch as an example: Position 1 refers to FPV Mode; Position 3

corresponds to AL Mode. Position 1 and Position 3 can be exchanged.

ASSEMBLY SECTION

组装说明书

T4-3d

TA R O T AV I A T I O N T E C H N OL O G Y C O. ,LT D

塔罗航空科技有限公司