User Manual

5
II.Mounting & Configuration
1.Gimbal Controller Wiring Diagram & Descriptions
Battery
Power Supply:3S-6S Li (11V-26V)
* If you choose a battery to power up the gimbal and multi-rotor, please
make sure this battery meets requirements of both components.
Receiver
1.Conventional Receiver: connect it to the CH1/SBUS and CH2 Channel in the gimbal main
controller. Also, set Receiver Type and corresponding channel in the assistant software.
2.FUTABA SUBS or SBUS-2: connect it to CH1/SBUS channel in the gimbal main controller.
. Also, set Receiver Type and corresponding channel in
the assistant software.
MAKE SURE CH2 IS UNCONNECTED
3.If you have 5V power supply to the receiver, please disconnect the 5V power of
CH1/SBUS channel (RED Cable).
Video
Connect the video wireless transmission module to AV OUT port. DO NOT
misconnect signal and video cable.
Gimbal can work independently without Tarot ZYX-M Flight Control Module, but its
performance might be influenced. For instance, angle offset might occur when
the accelerated state lasts for a long time.
Camera
Flight
Controller
The gimbal will connect the camera through “GoPro Charging & AV-OUT Cable”.
Descriptions：
Wiring Diagram
If you are pursuing a perfect performance, please connect the gimbal and Tarot
ZYX-M Flight Control Module to the DATA/FC channel of gimbal controller
through the special cable in main components pack.
ASSEMBLY SECTION
组装说明书
T4-3d
TA R O T AV I A T I O N T E C H N OL O G Y C O. ,LT D
塔 罗 航 空 科 技 有 限 公 司